Difference between revisions of "Mining NKN with Linux"
From NKN Community Wiki
(Created page with "📌 This guide will help you to install a NKN node using Linux.") |
|||
| Line 1: | Line 1: | ||
📌 This guide will help you to install a NKN node using Linux. | 📌 This guide will help you to install a NKN node using Linux. | ||
=== Requirements === | |||
{| class="wikitable" | |||
|+NKN Node tech requirement | |||
!Spec | |||
!Requirement | |||
|- | |||
|Operating system | |||
|Ubuntu is recommended (works perfectly with Debian) | |||
|- | |||
|Memory | |||
|1GB | |||
|- | |||
|Hard Drive Disk | |||
|25GB (SSD is recommended) | |||
|- | |||
|CPU | |||
|Most of them works (AMD, ARM, MIPS,...) | |||
|- | |||
|Internet connection speed | |||
|10Mbps up and down is a minimum | |||
|- | |||
|Internet usage | |||
|The amount of data used per month can be as high as multiple TB per month | |||
|- | |||
|IP address | |||
|1 IP version 4 (IPv4) is require per node. There is no way (and it would make no sense) to run multiple node on a single IP. IPv6 is not available. | |||
|- | |||
|Port forwarding | |||
|You need to be able to reach the TCP/UDP ports 30001-30021. Optionally the TCP ports 30022-65535 for NKN Commercial services like nConnect. See our page about [[Port forwarding for your NKN node|port forwarding]] | |||
|} | |||
=== Before you start === | |||
Please be sure to check all the following points | |||
* [ ] I have 10.1NKN mainnet tokens (or I'm ready to buy them) | |||
* [ ] My server is connected to internet | |||
* [ ] I have setup my port forwarding | |||
It's now time to ask yourself an important question | |||
Revision as of 03:13, 27 July 2021
📌 This guide will help you to install a NKN node using Linux.
Requirements
| Spec | Requirement |
|---|---|
| Operating system | Ubuntu is recommended (works perfectly with Debian) |
| Memory | 1GB |
| Hard Drive Disk | 25GB (SSD is recommended) |
| CPU | Most of them works (AMD, ARM, MIPS,...) |
| Internet connection speed | 10Mbps up and down is a minimum |
| Internet usage | The amount of data used per month can be as high as multiple TB per month |
| IP address | 1 IP version 4 (IPv4) is require per node. There is no way (and it would make no sense) to run multiple node on a single IP. IPv6 is not available. |
| Port forwarding | You need to be able to reach the TCP/UDP ports 30001-30021. Optionally the TCP ports 30022-65535 for NKN Commercial services like nConnect. See our page about port forwarding |
Before you start
Please be sure to check all the following points
- [ ] I have 10.1NKN mainnet tokens (or I'm ready to buy them)
- [ ] My server is connected to internet
- [ ] I have setup my port forwarding
It's now time to ask yourself an important question
